Getting the Heat Right in Your Bathroom
When you’re looking at infrared heaters, it’s tempting to just grab the one with the biggest number on the box. But that’s usually a mistake. If you overdo it, you’re basically paying to turn your bathroom into a sauna. If you go too low? You’re still shivering while you dry off. It’s all about the size of the room. Small powder rooms(anything under 4 square meters) don’t need much. A 400W to 600W unit is plenty. These spaces heat up fast, and a smaller unit keeps things comfortable without making the room feel stuffy. Formedium bathrooms(roughly 5-9 square meters), you’ll want something in the 800W to 1200W range. This is that sweet spot where you get that immediate “hug” of warmth the second you step in, but the air stays steady. Then you’ve got thebig master bathsor rooms with high ceilings. For those, go for 1500W or more. Here’s the thing: if you try to cheap out with a low-wattage heater in a huge room, the thing will just run 24/7. It’ll never actually get the room warm, which just kills the heater faster and makes your electric bill jump. Now, let’s talk about the water. Bathrooms are damp, and electricity and water are a terrible mix. That’s why we stick with IP65-rated gear. In plain English, it means the internals are sealed tight against dust and water splashes. You can put these in “Zone 1” areas, but please, be careful with the gaskets during install. If you pinch a seal, the protection is gone. Simple as that. One last tip: check your wiring. A 1500W heater pulls a lot of power. If your home has old, thin wiring or a weak circuit breaker, you’re probably going to trip the power the moment you flip the switch. It’s worth spending five minutes checking your electrical setup now so you don’t have to pay for a costly rewiring job later.